Yaskawa Modbus TCP/IP SI-EM3D Manual do Utilizador descarregar pdf (Página 27)

<5> The setting specifies that the Torque Reference or Torque Limit is to be provided via network communications

(F6-06 = 1). The motor may rotate if no torque reference or Torque Limit is supplied from the PLC.

<6> Parameter setting value is not reset to the default value when the drive is initialized.

<7> Cycle power for setting changes to take effect.

<8> When F7-13 is set to 0, parameters F7-01 to F7-12 must be set, and all IP Addresses (as defined with parameters

F7-01 to F7-04) must be unique.

<9> When F7-14 is set to 0 or 2, parameter F7-15 must be set.

<10> Setting range differs depending on drive software version. PRG: 1020 and earlier, Range: 0 to 2

PRG: 1021 and later, Range: 0 to 8

<11> Setting range differs depending on drive software version. PRG: 1020 and earlier, Range: 10, 100

PRG: 1021 and later, Range: 10; 100 to 102

Table 5 Option Monitors

No. Name Description Value Range

U6-80

U6-83

Online IP Address

IP Address currently available; U6-80 is the most significant

octet

0 to 255

U6-84

U6-87

Online Subnet Subnet currently available; U6-84 is the most significant octet 0 to 255

U6-88

U6-91

Online Gateway

Gateway currently available; U6-88 is the most significant

octet

0 to 255

U6-92 Online Speed Link Speed

10: 10 Mbps

100: 100 Mbps

U6-93 Online Duplex Duplex Setting 0: Half, 1: Full

U6-94 Port 2 Speed Port 2 Link Speed 0: Half, 1: Full

U6-95 Port 2 Duplex Port 2 Duplex Setting

10: 10 Mbps

100: 100 Mbps

U6-96 RSTP RSTP Role and State 0000 to 9292

U6-98 First Fault First Option Fault –

U6-99 Current Fault Current Option Fault –

6 Related Drive Parameters

YASKAWA TOEP YAICOM 18A 1000-Series Option Dual-Port Modbus TCP/IP SI-EM3D Installation Manual

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 51 52

Sem comentários

Yaskawa Modbus TCP/IP SI-EM3D Manual do Utilizador Página 27