Yaskawa Ladder Works Programming Manual Manual do Utilizador descarregar pdf (Página 180)

9.3 Trace Function (TRACE)

9-5

9.3 Trace Function (TRACE)

[Outline]

Performs execution control of the traces of the trace data designated by the trace group No. The trace

is defined as "Data Trace Definition" screen.

•

Tracing is executed when the trace execution command (Execute) is set to ON.

•

The trace counter is reset when the trace reset command (Reset) is set to ON.

The trace end (Trc-End) output is also reset at this time.

•

The trace end (Trc-End) output is set to ON when the trace execution count becomes equal to the

set count (set as Trace Definition).

[Format]

Symbol : TRACE

Full Name : Trace

Category : SYSTEM

Icon :

[Parameter]

I/O

Definition

Parameter Name

I/O

Designation

Setting

Execute B-VAL Trace execution command

Reset B-VAL Trace reset command

Input

Group-No I-REG Designation of the trace group

Trc-End B-VAL End of Trace

Error B-VAL Occurrence of error

Output

Status I-REG Trace execution status

Configuration of the Trace execution status (STATUS) is described below.

Table 9.1 Configuration of the Trace Execution Status

Name Bit No. Remarks

Trace Data full Bit 0 This becomes ON after one round of

reading of the contents in the data trace

memory of the designated group has been

competed.

System Reserved Bit 1 to Bit 7

No trace definition Bit8 The function will not be executed.

Designated group No. error Bit9 The function will not be executed.

System Reserved Bit 10 to Bit 12

Execution timing error Bit13 The function will not be executed.

System Reserved Bit14

System Reserved Bit15

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 219 220

Comentários a estes Manuais

Sem comentários

Yaskawa Ladder Works Programming Manual Manual do Utilizador Página 180

Comentários a estes Manuais

Manuais e produtos relacionados com Equipamento Yaskawa Ladder Works Programming Manual